Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Before
After
Before
After
Before
AfterAmarr Cable & Drum Replacement: The Bee Cave Owner’s Guide
Amarr cable and drum replacement in Bee Cave typically runs $130-$250 installed, and we carry the parts on the truck for most Amarr residential models, so we’re usually in and out the same day. You’ll know something’s wrong when you hear a pop, see a frayed cable hanging loose, or one side of the door sits visibly lower than the other. That cable is under serious tension, and when it goes, the door can drop hard or jam crooked. Don’t run the opener while it’s like that. Call us at (737) 221-2436 and one of us will head your way.
Which Amarr Models This Applies To
We stock cables and drums for Amarr’s residential lines, the most common around Bee Cave being the Classica, Heritage, Lincoln, and Oak Summit series. Amarr uses a matching pair of cables and tapered drums that are sized to your door’s height and spring system, so the drum for a 7-foot door is not the same one that goes on an 8-foot. The cable length and drum taper have to match your specific setup, not just any Amarr part number. If you can, look for the white label on the inside edge of the door panel, usually near the hinges. It’ll have the model and serial number. If you can’t find it, we’ll identify what you have when we arrive.
We’re an independent shop, not affiliated with Amarr, which means we can use genuine Amarr parts or quality aftermarket equivalents. For cables and drums specifically, we lean toward OEM-spec or known-good aftermarket parts that match the original diameter and taper. The drum is cast or machined, and if the grooves are worn uneven, the cable won’t spool clean, and your fresh cable will shred in months. We don’t put cheap parts on a door that weighs 200 pounds.
Signs Your Amarr Cable & Drum Replacement Is Failing
- A frayed or rusted cable. You’ll see broken strands spreading near the bottom bracket or drum. This is the most common failure in Bee Cave, where humidity near the Hill Country takes a toll on uncoated cables. Once strands start popping, the whole cable is done.
- The door hangs crooked or jerks on the way up. That means one cable has lost tension or slipped off the drum. The door is now riding uneven, and every cycle wears the tracks and rollers harder.
- A rough or chattering sound near the top of the tracks. The drum grooves are worn, or the cable is jumping out of its groove. That’s metal on metal, and it only gets worse.
- The door is heavier than normal to lift by hand. A broken cable removes the counterbalance on one side, so you’re now lifting the door’s full weight. It’ll feel twice as heavy, because it basically is.
- You see slack cable when the door is open. That slack means the cable has come off the drum or stretched. If it catches on anything, it can snap and the door can drop. Treat this one as urgent.
Replacement Cost & What’s Included
For Amarr cable and drum replacement in Bee Cave, you’re generally looking at $130-$250 installed, depending on whether we’re replacing one cable or both, and whether the drums need to be swapped too. We always replace cables in pairs, because if one let go, the other one has the same mileage and the same rust. You don’t pay for a second cable that fails next month and a second trip to fix it. The price includes the parts, the labor, and the adjustment to the spring tension so everything runs balanced. It’s quoted before we start and that number doesn’t change when we’re standing in your garage. We also offer $40 off any repair over $200, and a permanent 10% discount for seniors and veterans. Every job carries our 90-Day Done Right Promise: if it’s not done right, we make it right. One call and I come back, no runaround.
DIY or Call Us?
Here’s the short version: you can check the cables, but you shouldn’t replace them yourself. The cables on an Amarr door are under the same tension as the springs, and if that tension releases while you’re wrenching on a bottom bracket, it can take a finger or worse. That’s not scare talk. That’s just what a high-tension cable does when it lets go. What you can do safely: look for frayed strands, check the drums for obvious wear, and see if the door sits level. Then call us. This is one of those repairs where the price is fair, and the risk of doing it wrong is high. If you’re in Bee Cave and want it done right the first time, call (737) 221-2436.
FAQs
In the Bee Cave area, you might get eight to twelve years out of factory Amarr cables before rust or fatigue catches up, but coastal humidity, salt air, or a door that’s been run out of balance can cut that in half. Tell me what it’s doing wrong and I’ll tell you what it actually needs. Call (737) 221-2436 for a straight answer on yours.
No, a frayed or broken cable cannot be spliced or repaired; it must be replaced. Any repair on a tension cable is a short-term patch that’s waiting to snap, so we replace the pair and check the drums while we’re at it. Call (737) 221-2436 for an exact quote, estimates are free.
Most Amarr cable and drum replacements take 45 minutes to an hour and a half once we’re in the driveway. We stock the common sizes on the truck, so there’s no waiting on a part delivery. Call (737) 221-2436 and we’ll give you a time window that morning.
We stock the Amarr-spec cable sizes and drum tapers for most residential doors, so we can usually do the job in one visit. If your door is an unusual height or weight rating, we’ll have the part ordered within a day. Call (737) 221-2436 and we’ll verify compatibility over the phone.
Written by Otto Reinhardt, Owner, Otto’s Garage Door - Bee Cave, TX at Otto’s Garage Door, serving Bee Cave and nearby areas.